NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Volume Scan Failed to Run Properly during boot
I have a ready nas business edition with iscsi enabled.
It is running the latest firmware. If I reboot it normally without checking :
| Perform volume scan on next boot. This process can take several minutes to more than an hour depending on disk capacity and volume content. | |
 | |
| Check and fix quotas on next boot. This process can take several minutes to more than an hour depending on disk capacity and the number of files on your volume. |
the NAS boots fine, but if I try and check both or either of these two boxes, the NAS hangs during the boot process. I did get a notice awhile back that I needed to backup all data and check and repair volume.
Please advise.
3 Replies
Replies have been turned off for this discussion
Hi eihelp,
Welcome to the community!
There might be a problem with the disks installed in your system that's why it stops or hangs during the normal boot process. Can you extract the logs so we can have a look?
Kind regards,
BrianL
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
