- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Cable Modem Nighthawk AC1900 C7000 bridge to router
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cable Modem Nighthawk AC1900 C7000 bridge to router
Hi everyone,
I just bought Netgear modem/router Nighthawk AC1900 C7000 100Nas. I was using it as a router, but it conflicted with my other router (NAT), a Linksys. I changed the mode from Router to Bridge, but now I cannot get inside Nighthawk anymore (192.168.0.1). Is there anyway I can get inside? How about reverting the mode from bridge to router? I found a solution on how to keep Netgear as a router with no NAT conflicting issues with linksys router and I would like to try that, but can't, unless I change mode from bridge to Router again. I hope the solution bridge to router is not RESET as I will lose ISP activation (TWC) and have to do it again.
Thanks a lot for helping.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Cable Modem Nighthawk AC1900 C7000 bridge to router
thanks for posting on community 🙂
If you changed C7000 from Router Mode (NAT) to Bridge mode. You can access the router via Private Subnet (192.168.100.1) by "DIRECTLY" connecting your laptop to the C7000
If you have problems with that, let me know.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more