- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Netgear LM1200 failover
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Netgear LM1200 failover
So I was reading a few forum topics re: the LM1200 and it's failover functionality and I wasn't able to resolve the issue I am having.
I am on Netgear LM1200 firmware version EC25AFFDR07A09M4G, app version NTG9X07C_20.06.09.00.
The Netgear Orbi firmware is V6.0.3.85_3.1.15
The LM1200 is set to "bridge mode", and the Netgear Orbi router is set to automatic DHCP for the 10Gbps WAN port.
Automatic failover is enabled.
Connection keep alive is set to ping 8.8.8.8 every minute.
Here's scenario one, when the cable modem is unplugged, and the LM1200 grabs the WAN from AT&T
Here is scenario two, with the cable modem plugged in:
And here's scenario three, where I just plug my laptop directly into the LAN port of the LM1200, with the cable modem connected and Internet up:
Any ideas?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Netgear LM1200 failover
Troubleshooting attempted:
- Rebooted LM1200 with cable modem connected to WAN port on LM1200, Orbi router connected to LM1200 LAN port
- Rebooted Orbi router (with same cables connected as above)
- Rebooted Cable modem (with same cables connected as above)
- Rebooted everything (with same cables connected as above)
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more