- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: DGN2200v4 in AP Mode: Access Control is greyed out
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
DGN2200v4 in AP Mode: Access Control is greyed out
Hi
After upgrading DGN2200v4 to firmware V1.0.0.86_1.0.86 I cannot access to "Access Control": it is greyed out.
The router is set up in AP Mode.
Why did you remove features in firmware upgrade? Will it be restored in future?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGN2200v4 in AP Mode: Access Control is greyed out
Did you "factory reset" you flashed the firmware.
after
New firmware sometimes introduces changes that are not compatible with the old configuration.
So a factory reset is the first thing to try if you have problems with new firmware.
Backup your configuration first. Netgear does not advise restoring old settings into new firmware, but if resetting does not fix your problem, and you have complicated settings, you might want to restore them, especially if you roll back to earlier firmware.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: DGN2200v4 in AP Mode: Access Control is greyed out
Thank you michaelkenward, but every time I upgrade the firmware I also did a factory reset without uploading a previous backup of configuration.
I have already done the factory reset.
The "Access control" option is greyed out in AP mode.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more