NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
How to setup LAG between 2 Netgear switches?
I'm trying to setup LAG between 2 Netgear switches, but its not working. The switches I'm using are S3300-52X-PoE+ ProSAFE 48-Port Gigabit Stackable Smart Switch with PoE+ and 4 10G uplinks and XS72...
Here again, the same setings must be used on both ends. And for the obvious (?) reasons, only one VLAN can be run untagged and with the same PVID configured.
tonynsx wrote:I have both switches on Static lag.
This means much less assistence - a properly configued and working LACP LAG woud show if there is something wrong. On static LAG, you just have the links.
tonynsx wrote:On the 52 port switch, when I connect the SFP+ cable, it says link up on ports 51, and 52 on LAG 1, so looks like the 52 port switch is configured right.
This does just proof there are two links. Point. Nothing else.
tonynsx wrote:I cannot get to the 28 port swith, so I can't look at its settings, but its setup the same way as the 52 port
This does make things a little bit hmmmmmm Tonyyyyyyyyyyyyyyy, hey?
Update, I have the LAG same way on both switches, but I changed it from untagged (U) to tagged (T), and now on both switches, LAGs are showing up. I'm able to ping both switches now.
So the LAG isn't the issue - the VLAN association is (or was).
I suppose so, but in the documentation it says I can use U or T, besides the cat 5 trunk was using U
Here again, the same setings must be used on both ends. And for the obvious (?) reasons, only one VLAN can be run untagged and with the same PVID configured.
Ok, I appreciate your help
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
