Usage: ubifsmount <volume-name> - mount 'volume-name' volume UBIFS not mounted, use ubifs mount to mount volume first! ubifsload - load file from an UBIFS filesystem
Usage: ubifsload <addr> <filename> [bytes] - load file 'filename' to address 'addr' Wrong Image Format for bootm command ERROR: can't get kernel image! Saving Environment to SPI Flash... done UBIFS not mounted, use ubifs mount to mount volume first! ubifsload - load file from an UBIFS filesystem
Usage: ubifsload <addr> <filename> [bytes] - load file 'filename' to address 'addr' Wrong Image Format for bootm command ERROR: can't get kernel image! Saving Environment to SPI Flash... done UBIFS not mounted, use ubifs mount to mount volume first! ubifsload - load file from an UBIFS filesystem
Usage: ubifsload <addr> <filename> [bytes] - load file 'filename' to address 'addr' Wrong Image Format for bootm command ERROR: can't get kernel image! ETH LINK UP: 1000FD BOOTP broadcast 1 BOOTP broadcast 2 BOOTP broadcast 3 BOOTP broadcast 4 BOOTP broadcast 5
Retry count exceeded; starting again
Model: GSM4328PB|M4300-28G-PoE+ - 24x1G PoE+ Stackable Managed Switch with 2x10GBASE-T and 2xSFP+ (1000W PSU)
In my oppinion that's definitely a case where you should reach out to Netgear and open a case on my Netgear. That switch - unless you are not the original/first owner - is covered by a lifetime warranty.
Although that could be restorable, it points into corrupted flash. IMO not worth the hassel. This can happen but its fortunately something with rare occurence that I haven't had this happen on any of our M4300 here. But that's where the lifetime warranty is for. 🙂
Your message is to short to help you any further 😕
Didn't they react upon your request, or were you unable to open a case? You need to register the switch, then open a chat request. I've done it a couple of times and never had any issues. Please tell us what issues you are encountering.
