Netgear M4100-26G Switch POST Problem

[Marcos999]

Hi everybody!

I´m opening a new discussion after discovering the reason of my issue. This is my Problem:

3. Check the Power LED on the front panel of the switch.
The LED should light in the following sequence:
• The LED turns yellow as the switch runs a power-on self-test (POST).
• If the switch passes the test, the LED turns green. The switch is working and ready to
pass data.
• If the POST fails, the Power LED blinks yellow.

Now I know why the power LED doesn´t stop blinking yellow, but i can´t find a solution in any of the official manuals. Does someone know what should I do now?

Link to the first discussion about this issue:

Install Firmware after Hard-Reset Netgear4100-26G - NETGEAR Communities

[JeraldM]

Hi @Marcos999,

Were you able to access the boot menu of the switch to perform a Factory Defaults? For your reference, please check this KB article.

If not, I suggest to contact support and request for a replacement, here are the steps on how to do so.

Regards,

JeraldM

NETGEAR Community Team