- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
firmware upgrade on m5300 stack advice needed
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
we are trying to upgrade firmware on our 2 switch stack .
after uploading and reset power we have ' Code Mismatch'
unit 1 has 11.0.0.40
unit 2 has 11.0.0.31
Unit 2 is active.
Could we get advise to fix this issue?
thanks
Robert Fantini
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i just read https://community.netgear.com/t5/Managed-Switches/M5300-stack-firmware-upgrade/m-p/1424976#M4850
and realized that both switches probably did not get a power reset. will try that tomorrow.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i just read https://community.netgear.com/t5/Managed-Switches/M5300-stack-firmware-upgrade/m-p/1424976#M4850
and realized that both switches probably did not get a power reset. will try that tomorrow.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: firmware upgrade on m5300 stack advice needed
reboot of the switch running the older code fixed the issue.
note that after fw is updated, rebooting one switch at at time works. choosing all is as far as I remember was done after the new fw was uploaded.