- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
M560 mesh router with 2 satellites won't sync
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
M560 mesh router with 2 satellites won't sync
I have had this 2 satellite router for 2 years. Main router is in living room and 1 satellite in bedroom. 'Both work fine. I have the 2nd satellite in 1 br apt. next door about 30 ft from other satellite. It was working when I first set it up, but I just noticed orange light. I have unplugged, hit reset and hit sync button many times. I disconnected main router for 60 seconds, synced both main and satellite at the same time, put satellite within 6 ft of main router. Nothing will cause satellite to sync. Is it dead? Thanks for any held
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: M560 mesh router with 2 satellites won't sync
Turn OFF the other MS and try to sync the one MS to the MR.
Might remove the one entry seen on the MRs web page under connected devices if he shows a disconnect button there. Then reboot the MR then try to resync the MS.
Try a factory reset on the MS and MR and setup from scratch. I'd leave the other MS OFF.
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more