MS60 mesh satellite from another set

[Inner]

I have two sets of mesh systems each with an MR60 and two MS60

how can I Sync the MS60's from both sets to one of the MR60's

I tried Unplugging one of the MR60's and then doing a 30-30-30 reset on the MS60's and then attempted to Sync on the running MR60 and it just wont connect to the other MR60.

the MS60's will only connect to their respective original MR60.

Is there any way to do this so I can have the 4 MS60's on one MR60.

[FURRYe38]

Is FW loaded the same version across all units? 

Pressing the sync button the MS from the 2nd set and pressing the sync button the MR from the 1st set doesn't work? 

[Inner]

I will have to check on the firmware. they were bought at the same time but that doesn't mean anything.

No I attempted to sync over and over again I even moved the devices into the same room right next to each other and still pressing the sync on both units they eventually time out.

I even logged into the Web Interface and tried from there.

[plemans]

Did you try hardwiring in the new satellites to the mr60 and syncing them?