5025895M005FE

[thelung]

Corrupt Firmware after internet drop out blinking red power light
Unable to use or restore firmware

[plemans]

sounds like you might have corrupted the firmware during the update. 

You can try recoving it with tftp or nmrpflash.  

are you on windows? if so, follow this guide

https://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTP

just make sure you enable tftp 

https://www.thewindowsclub.com/enable-tftp-windows-10

and here's a video walk through using a tftp client. Use the built in one for windows 10 though. the video is more of an example of how its done. 

https://www.youtube.com/watch?v=R9DLrLQrpaw

and if that doesn't work, you can try using nmrpflash

https://github.com/jclehner/nmrpflash

[thelung]

hi

thanks for the reply im unable to reflash the firmware as im not good with computers 

is there any o way this can be done with granting romote access

thanks

[plemans]

You don't have to be good with computers. The guides walk you through each step of the process. 

There's even a video example of how to do it. 

[thelung]

Just tried again and the firmware flash gets about three quarters of the way on first flash then fails

[plemans]

what error does it give you? 

What type of device are you using? 

did you flash with tftp or nmrpflash? 

If tftp, did you enable it within windows? 

[thelung]

No error code just stops after flashing
Just over half way on the progress bar
I’m using a window 10 laptop and have enabled tftp trying to re flash a netgear X6S extender