Most of the ethernet cables are at least cat 5 but there is at least a couple of them which are newer cat 6 cables. Im sure the cable from modem to router is cat 6 and also the cable from the switch to router is also cat 6. The switch model is netgear GS308V2.
It's recommended to run same version of CAT# cable and not mix newer versions with older versions.
Also CAT5 does not officially support 1000Mpbs connection rates. 5E is were that started. Cables are fairly inexpensive these days and you might take a overall sweep and upgrade to all CAT6 to be sure all is good there.
Yeah that is something that i could do, ordering a few new cables wont be an issue. Is worth a try but i dont think the cabling is the issue but i could be wrong. Apart from the rax70, my setup and cabling is exactly the same as before and never had any issues. I upgraded as my R7500 was quite a few years old, so thought after a couple of months of having the new 1gb broadband i would get a more modern router. Had no issues with anything internet related or disconnections, has only occurred since after installing the rax70.
Well lets hope this maybe helpful to the RAX80 owners since this is a RAX80 thread. I wouldn't presume they are the same however may not be much different either. Anything is possible when it comes to these things.
Enjoy your RAX70. Be sure to save off a new backup configuration to file. Saves time if a reset is needed.
Hi All , I took a chance to factory reset RAX80 and then upgrade to latest firmware V1.0.10.140_1.0.79. No settings restored from back up - all clean and fresh . Still I see internet connected statements in log twice a day. I dont really care this disconnection now a days because my WFH laptop is directly connected to AT&T fiber hub through LAN because it is not fun to drop VPN during work. Rest all my household use RAX80 which is a pass through from fiber hub. The bottom line is latest firmware did not help. Awaiting responses from others who upgrade to latest firmware. Good luck Netgear fans!
Hi All , I took a chance to factory reset RAX80 and then upgrade to latest firmware V1.0.10.140_1.0.79. No settings restored from back up - all clean and fresh . Still I see internet connected statements in log twice a day. I dont really care this disconnection now a days because my WFH laptop is directly connected to AT&T fiber hub through LAN because it is not fun to drop VPN during work. Rest all my household use RAX80 which is a pass through from fiber hub. The bottom line is latest firmware did not help. Awaiting responses from others who upgrade to latest firmware. Good luck Netgear fans!
Im aware this is an rax80 thread, was just the closest possible thread i found with people experiencing the same or similar issues. I dont believe there is massive difference compared to the rax70 in general but could be wrong
@Djg1984 wrote: Im aware this is an rax80 thread, was just the closest possible thread i found with people experiencing the same or similar issues. I dont believe there is massive difference compared to the rax70 in general but could be wrong
