- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Missing confirm button when manually updating firmware.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Missing confirm button when manually updating firmware.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Missing confirm button when manually updating firmware.
You might get more help, and find earlier questions and answers specific to your RBR50 device, in the appropriate section for your hardware. That's probably here:
Orbi - NETGEAR Communities
I will ask the Netgear moderator to move your message.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Missing confirm button when manually updating firmware.
Downgrading from v4 to v3 is not supported.
Try a factory reset on the RBR and RBS and setup from scratch. If your problems continue, please open a support ticket with NG.
@bestsongever99 wrote:
When trying to manually update my firmware to downgrade? Since "updating" to new version V4.6.3.7_2.0.49 I have been having issues connecting to Wi-Fi, dropping connections when streaming Plex or any type of service at least twice every 10 minutes sometimes more. But when I tried to manually update my firmware I setup the RBS750 just fine but then after I try to do the router and apparently they remove the yes/confirm button so I'm stuck with this update that has been horrible right after I downloaded it. Sometimes certain devices can connect to the Wi-Fi but it can't connect to the internet even though it's available but if I open a guest Network they can log in just fine. Does anybody have any ideas for me please? Also I have the RBR75 Orbit AX4200 Tri-band wiFi Router but of course it's missing from their model list.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Missing confirm button when manually updating firmware.
The downgrade from FW v4.6.3.7 back to 3.2.18.1 is not supported. Therefore you will notice that there isn't an option to click "Yes".
Please check your inbox. I have sent you a message requesting for more information.
Regards,
Blanca
Community Team
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more