I manually updated my RBR850 and Satellite with the 3.2.17.12 firmware and having random disconnects since. Anyone else? This is the first time I've run into issues in the 6+ months that I've used it.
Thanks for the reply! I've rebooted, but not reset and setup from scratch. Is that really needed for every firmware upgrade? Yikes! No, the traffic meter is off (double-checked to make sure). I'm connected directly to my Verizon FIOS ONT.
Okay, I'll rebuild if it keeps happening. It shouldn't be too bad.
I don't know about the ONT. I assume so as it's working without the cable router. We had Verizon make changes to the ONT years back as we weren't using the cable boxes and I purchased my own router. I didn't realize it worked without the router until I mistakenly hooked up the Orbi system, got it working, and realized the Verizon modem was sitting on the kitchen table. Oops!
Thanks for the reply! I've rebooted, but not reset and setup from scratch. Is that really needed for every firmware upgrade? Yikes! No, the traffic meter is off (double-checked to make sure). I'm connected directly to my Verizon FIOS ONT.
Out of curiosity, did you do a 'soft reboot' - use the reboot function in the app or gui - or a 'hard reboot' with the button or better yet, completely pulling the power cord for a minute?
All of the above. First a soft reboot from the App using Access Anywhere. After, it appeared that the majority of traffic was on the satellite. I pulled the power on the satellite, then the router. Plugged the router back in, then the satellite and it worked well for a few hours. Another outage hit later in the day that resolved with a soft reboot from the app. So far so good.
