- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range
So I'm trying to assign a static IP for a raspberry pi. I originally assigned it using the IP Reservation panel and assigned, 192.168.1.97, rebooted, and then when I would connect the pi to the network, the network went down. I then read another thread where someone recommended changing the range to 192.168.1.100 - 192.168.1.200 so I changed the IP range to that.
Now the network comes up, but every time I try to load the Attached Device page it hangs, and if I try to change the IP range back to the original range, I get a:
"400 Bad Request
This server does not support the operation requested by your client."
Displayed. Any help would be appreciated!
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range
v2.5.0.38 was bad/pulled from NG support website. The new attached device regconition feature has since been fixed in the latest firmware version 2.5.1.8.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Orbi RBR50 on V2.5.0.38 no longer shows attached devices after changing IP range
Im on 2.5.1.8, doesn't work for me. I have a new thread going
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more