RBS20 Power Flashing Red

[JAKPhoto]

My RBS20 power is flashing red. The light on top is pulsing white. This happened after the last firmware update. I’ve tried to factory reset the unit numerous times with a paper clip holding down for 30 seconds. I tried the 30/30/30 reset too. I tried a different power adapter.
Any suggestions?

[antinode]

> My RBS20 power is flashing red. [...]

      https://community.netgear.com/t5/x/x/m-p/2122679

[FURRYe38]

https://kb.netgear.com/000059634/How-to-upload-firmware-to-a-NETGEAR-router-using-Windows-TFTP
Need to press the reset button for 30 seconds then release, then it send to PUT the command and upload the FW. 
I had a problem on a Windows 10 PC where this didn't work to use TFTP, so I switched to a WIndows 7 PC and the TFTP worked.

Try nmrpflash?
https://github.com/jclehner/nmrpflash

---

@JAKPhoto wrote:
My RBS20 power is flashing red. The light on top is pulsing white. This happened after the last firmware update. I’ve tried to factory reset the unit numerous times with a paper clip holding down for 30 seconds. I tried the 30/30/30 reset too. I tried a different power adapter.
Any suggestions?

---