- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GS108Tv2 cannot disable port mirroring
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I recently enabled port mirroring on this switch (after messing a lot with confusing error messages). Now I'd like to disable again, but I can't. I was able to set "Session Mode" to "Disable" again, but I'm not able to completely remove mirroring config. Trying to do so will result in "Error! Unknown Interface":
Any idea how to fix this apart from doing a factory reset?
Software version is 5.4.2.22 (upgrade to 5.4.2.36 won't work either)
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@lsng wrote:
Now I'd like to disable again, but I can't. I was able to set "Session Mode" to "Disable" again, ...
There is no more disable than disabling the port mirroring session. It's disabled at that point, perfectly fine.
@lsng wrote:
but I'm not able to completely remove mirroring config. Trying to do so will result in "Error! Unknown Interface":
No way to "remove" the pre-set mirroring config(s).
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
@lsng wrote:
Now I'd like to disable again, but I can't. I was able to set "Session Mode" to "Disable" again, ...
There is no more disable than disabling the port mirroring session. It's disabled at that point, perfectly fine.
@lsng wrote:
but I'm not able to completely remove mirroring config. Trying to do so will result in "Error! Unknown Interface":
No way to "remove" the pre-set mirroring config(s).
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GS108Tv2 cannot disable port mirroring
Well then, if you say so 😀
Thanks!