GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and stuck with old firmware

Question

GS108Tv3 did not take an update, so does anyone has the same problem?&nbsp;I already rebooted and tried the update repeatedly, but it seems it stuck with 7.0.7.1, so please help!&nbsp;Thanks!

schumaku · Answer

The switches have two firmware images on board. Have selected the correct image to become active after the reboot?

cat139lyleb · Answer

Did that too, same result...

schumaku · Answer

What is show on1. Configure dual image settings on (user manual page 447), and2 The dual image status (user manual page 449)?

cat139lyleb · Answer

Where the manual book or something? Also how do I suppose to do with 2 ways firmwares updates, I thought it should be simple to do as same as what routers do...

schumaku · Answer

cat139lyleb&nbsp;wrote:
Where the manual book or something?

There is one way for the firmware update. However there are two firmware images in place, which can be maintained individually. You as the switch admin define which image will be activated following the installation, or which image you want to have loaded following a reboot or cold start. Can't take away your learning curve.
&nbsp;
https://www.netgear.com/support/product/gs108Tv3.aspx&nbsp;
https://www.netgear.com/support/product/gs108Tv3.aspx#docs&nbsp;
&nbsp;
cat139lyleb&nbsp;wrote:
I thought it should be simple to do as same as what routers do...

It's not that straight forward I'm afraid.

Forum Discussion

GS108Tv3 Firmware Update Failure from old "7.0.7.1" to new "7.0.9.11" and stuck with old firmware

5 Replies

Related Content

Setting MTU on GS108Tv3

VLAN Routing GS108Tv3

GS108TV3 getting automatically disconnected

Steps to change the management VLAN for the GS108Tv3

GS108Tv3 - How to Use PoE Port?

NETGEAR Academy

ProSupport for Business