- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Where is the Bridge Mode?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Where is the Bridge Mode?
Can anyone tell me where the bridge mode is??
It should be.......Advanced tab > Advanced Setup and click Wireless Settings
but my login screen does not have an option for "Other operating mode".
Formware is V1.1.00.14.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
Once logged in to the Admin console, click the "Advanced" tab > Advanced Setup > Wireless Settings > at the very bottom is "use other operation mode" > Enable Bridge mode is hidden under this > place a check next to "use other..." and it should appear.
With some of the older routers, it was always there, but if you had a popup blocker enabled on your browser it seemed to make it.....not appear. Disabling it mitigated that.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
Check page 130 of the manual.
http://www.downloads.netgear.com/files/GDC/D6200/D6200_UM_17Sept2014.pdf
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
Your ISP probably only gives you 1 IP address. Normally, your modem/router gets it. When you enable bridge mode, the modem/router will stop using it but the downstream device may not necessarily pick it up. Try rebooting your modem. Then force the device connected to the modem to obtain the public IP address.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
Disconnect the gaming router from the D6200 then re-connect it.
Note: If your ISP uses PPPoE, PPPoA, L2TP etc., then you will need to set this up on your gaming router.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Where is the Bridge Mode?
Did you transfer the PPPoE settings from the modem to the gaming router?
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more