NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
[FVS336GV3] ERROR: miiSwitchRegisterRead: Timeout at page
After a reboot of a FVS336Gv3 I see a lot of this errors. Slow logon to the webinterface will happen and after several minutes no WAN -DMZ or WAN - LAN access is possible. I have configured the FVS33...
Hi thomaskrampe,
Welcome to the community! :)
Let us isolate the problem. Kindly answer the questions below:
a. Why did you reboot the FVS336Gv3?
b. For how long did it took before the internet access came back when you lost internet access after doing a reboot?
c. Did you happen to try to reboot the FVS336Gv3 again and does it show the same errors?
d. Does the problem happen all the time whenever you reboot the FVS336Gv3?
e. Have you ever check if you have internet access by connecting a PC straight to the modem after you lost internet access through the FVS336Gv3 to isolate the problem?
f. Did you modify any settings on the FVS336Gv3 recently before the problem occured?
g. Are there any changes within your existing network before the problem occured?
h. What is the current firmware version of your FVS336Gv3?
I look forward to your response.
Regards,
DaneA
NETGEAR Community Team
a. because it's done automatically every night
b.after reboot (it takes up to 5 min.) internet access inbound (outbound there is no problem), then between 1 h und 2 h no inbound connection is possible
c.again and again same result
d. yes
e. yes, no problem when I connect to the cable modem (but again no problem outbound)
f. no just the base configuration
g. nope, not as far as I know ;-)
h.
Firmware Version: 4.3.3-6 The problem is only for WAN to DMZ or WAN to LAN connections. I have a /29 public static subnet which points to the DMZ port with a separated switch (no vlan) and another switch connected to the LAN port. I use the FW in NAT mode and have all available IP-Addresses under WAN1 Secondary addresses (except the addresses from the cable modem and the firewall). Also during nromal operation I have a lot of miiSwitchRegisterRead: Timeout error in the log file.
Hello thomaskrape,
Can you try to uncheck "Block UDP Flood", see if this helps fix the issue. You can find this setting on Security>Firewall Rules>Attack Checks. You are already running on the latest firmware so I cannot say this is a firmware issue.
I hope this helps, let us know.
Thanks,
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
