Select your NETGEAR Community

I see this is an old post but I too have this issue. On a wired connection too.

I have 3 of these switches, one at each of 3 different locations, and the setups are similar for each, but not identical.   Is there a way to edit some .css or other file to change the color o...

Dear Support Team,   I am seeking assistance, and I kindly request your help.     I have encountered an issue with my NETGEAR M6 Pro MR6550 router. I purchased it two weeks ago, a...

Using signal strength detection to place Orbi Satellites   This document describes how to use signal strength detection of WiFi signal to optimally place Orbi satellites – location AND number ...

How do I make these compatible?

Glad you got it working. Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed. https://kb.netgear.com/000062080/How-do-I-back-up-the-configuration-s...

I updated my RBK853 to the 7.2.6.31 firmware manually. Updated from 7.2.6.21. Update went smoothly, no problems. First I updated the two satellites, then the router. After that, I powered off the thr...

Scroll UP on that same page...Its there.  @JoshDi wrote: Was update 7.2.6.31 pulled from the website? I only see 7.2.6.21 listed here: https://www.netgear.com/support/produ...

My 850 with three satellites auto updated and is working just fine.     

Was wondering why it still shows .21 until I looked closer and then saw it.  Surprised why Netgear didn't just put it under the download link instead, rather than in an support article section?