Select your NETGEAR Community

Hardware Version 1.01   Firmware Version V2.1.5.2   Cable Firmware Version V1.02.08   When the connection on the Nighthawk CAX80 changes from good to poor due...

I recently bought the AX6000 hooked it up update to latest firmware and ran a speed test. Was only getting 340-400 mbps out of the 1200 mbps. Also did the speed test on the Netgear app and only getti...

Netgear m5 router Only works on the external antennas. If it is disconnected from the external antenna, it does not work and a message appears mobile broadband is disconnected. It was working before ...

I have two R7000 routers.  One is the main router connected to the cable modem and the second is used as an access point.  Plus there is one more wired range extender in the storage area.&n...

All of a sudden the 5ghz and 2.4ghz have disappeared when scanning for our internet. The lights are both on and I have turned the router on and off a few times. I have no way to connect to the router...

My 850 with three satellites auto updated and is working just fine.     

thanks - I upgraded no problem on the router and two sats

Scroll UP on that same page...Its there.  @JoshDi wrote: Was update 7.2.6.31 pulled from the website? I only see 7.2.6.21 listed here: https://www.netgear.com/support/produ...

Was update 7.2.6.31 pulled from the website? I only see 7.2.6.21 listed here: https://www.netgear.com/support/product/rbk852/#download

Was wondering why it still shows .21 until I looked closer and then saw it.  Surprised why Netgear didn't just put it under the download link instead, rather than in an support article section?