A few days ago, I noticed that my MS60 diode is solid amber.
My setup:
MR60 is connected to an Internet (ISP's modem).
The same MR60 from Ethernet slot is connected to the wall.
A cable in the wall from the ground floor to the 2nd floor. It is Cat 5e cable.
On the 2nd floor, there is a 1Gbps switch connected to the wall (directly to MR60 but using 3 cables).
MS60 is connected to the switch.
It lights the solid amber diode, backhauled or not. If I bring it to the 1st floor without backhaul, it syncs with MR60 and lights a blue diode. If I bring it back to the 2nd floor, it's amber again, and the backhaul seems to be not working.
The Ethernet speed between a desktop on the 2nd floor and a desktop on the ground floor (so using the same cable in the wall) is ~870 Mbps and stable.
The firmware is the newest available, I tried resetting MS60, it seems to be working fine but it doesn't use backhaul.
Is there a way to "disconnect" or unpair MS60 from MR60, so if I bring it close and connect with backhaul there will be no way for them to sync wireless? I think I need to exclude Ethernet port failure in MS60 (however, the switch is blinking green when I connect MS60).
