Select your NETGEAR Community

Dear Support Team,   I am seeking assistance, and I kindly request your help.     I have encountered an issue with my NETGEAR M6 Pro MR6550 router. I purchased it two weeks ago, a...

Using signal strength detection to place Orbi Satellites   This document describes how to use signal strength detection of WiFi signal to optimally place Orbi satellites – location AND number ...

How do I make these compatible?

Hello Community,  I have a Netgear PR460X router with 3 M4250-26G4F-PoE+ daisy chained on 10gSFP. I have 5 VLANs : 1(MGMT and device traffic), 20(testing(, 25(Guest Network), 100(SIP ...

Not clear whether MoePA found a suitable UPS for his ORBI.  If someone has recommendation, I am trying to solve essentially the same issue - I would like a very small UPS for an ORBI satellite d...

I updated my RBK853 to the 7.2.6.31 firmware manually. Updated from 7.2.6.21. Update went smoothly, no problems. First I updated the two satellites, then the router. After that, I powered off the thr...

Glad you got it working. Be sure to save off a back up configuration to file for safe keeping. Saves time if a reset is needed. https://kb.netgear.com/000062080/How-do-I-back-up-the-configuration-s...

My 850 with three satellites auto updated and is working just fine.     

thanks - I upgraded no problem on the router and two sats

Was wondering why it still shows .21 until I looked closer and then saw it.  Surprised why Netgear didn't just put it under the download link instead, rather than in an support article section?