Select your NETGEAR Community

I am trying to get into hard wiring everything for my gaming setup and I would like a switch, possibly managed to be able to experiment with networking, but i am kind of confused on what would be com...

I just checked the scrub status (btrfs scrub status /data) for an ongoing scrub and see this:     total bytes scrubbed: 19.68TiB with 144 errors error details: csum=144 ...

Changed the internet provider, the new router does not have wps button. Tried factory reset, but a previous setting is still there. Should I have now netgear.ext? None of the netgear support explan...

my nighthawk CM2000 modem , looks to have the power led and the globe internet led burnt out can they be replaced. Everything seem to be working ok. the upstream and downstream led ar lit as is the m...

This is a multi-part question so bear with me while I explain this bizarre behavior, which isn't always the same exact bizarre behavior each time which makes it very difficult to figure out the cause...

(Updated) I initially thought "Bad luck" as I started by upgrading one of the thee satellites (an RBS850) ....and it was impossible to reconnect it to the the RBR. It keeps blinking white when boo...

Other satellites and then router went OK: everything is now up and running. Note that the administration console of the router has a popup warning discouraging to do manual firmware upgrade ....al...

Had anyone updated to this new version yet? Does everything work correctly?

I updated my 854 system Saturday. Using the manual FW update method: https://community.netgear.com/t5/Orbi-WIFI-6-AX-AND-Wi-Fi-6E-AXE/Procedure-for-Factory-reset-of-RBS850/m-p/2359585/highlight/tru...

RBR connected to a CM3000 cable ISP modem. 1Gb WAN Port on CM Modem. ISP - Sparklight 1Gb/50Mbps ISP Speed plan.  Armor, SPC and Traffic Meter not enabled.  RBR Onboard Speed T...