Connection port for managing XS708e

Question

Hi All,&nbsp;We have two XS708e installed in our collocation provider rack. They are used as SAN switches. When installing XS708e our engineer made mistake and did not&nbsp;connect the switches to our management network.&nbsp;&nbsp;Now we want to connnect the switches to management network and configure them with ProSafe utility.&nbsp;&nbsp;The question:&nbsp;Is it necessary to connect the management network to port #1 of the switches as shown in installation guide? Or we can use any port for this?

ElaineP · Accepted Answer

Hi Vohid,
&nbsp;
Welcome to NETGEAR community!
&nbsp;
You can use any port to connect the management network. If you do factory default on front panel, the default ip address is 192.168.0.239.
&nbsp;
Regards,
NETGEAR Employee

Forum Discussion

Connection port for managing XS708e

1 Reply

Related Content

XS708E Plus Switch Problems connecting to Admin Page

Service management offline

Netgear XS708e connecting to cisco Catalyst 2960

WAX220 v1.0.3.4 + Management VLAN + Radius + AP VLAN = No connection

Rax50 Manage Connected Devices

NETGEAR Academy

ProSupport for Business