NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
Remove access points from a controller
Hi I hope you guys can help. I have a set of WNDAP360's that were connected to a Prosafe WC7520 wireless controller, the AP's now nnned to installed on a different site with out a local control...
Hi haydenlawrie,
Welcome to the community! :)
Since you have already performed a factory reset and reloaded the firmware, it means that you were able to access the WNDAP360 web-GUI, am I correct? Kindly answer the questions below:
a. What is the status of the LED lights of the WNDAP360 when its turned on?
b. What is the current firmware version of the WNDAP360?
I look forward to your response.
Regards,
DaneA
NETGEAR Community Team
Hi DaneA
Thanks for getting back to me so quick, I have five of them and they are all doing the same thing.
1. Just a flash amber power light, no other lights at all
2. all of the default IP addresses have changed to 192.168.0.160
3. the firmware version I have downloaded and tried to apply is WNDAP360_V3.5.5.0 however even though the devices go through the install process they firmware is not applied, the current build is 2.3.0.37_1318.
If you need any more info please let me know.
Thanks again
Hayden
Hi haydenlawrie,
I suggest you to upload firmware v2.1.12 instead. Click on this link where to download firmware v2.1.12. Be reminded to perform a factory reset on the WNDAP360 after uploading the firmware. Let us know the results afterwards.
Regards,
DaneA
NETGEAR Community TeamHi DaneA
That did the trick..!!! :) thanks very much for that.
Many thanks
Hayden
Hi haydenlawrie,
You're welcome! :) I'm glad to know that it worked.
Feel free to post your future concerns here in the community.
Regards,
DaneA
NETGEAR Community Team
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
