NETGEAR is aware of a growing number of phone and online scams. To learn how to stay safe click here.
Forum Discussion
Solved
ReadyNAS 314 hard drive tray
Hello! I have a ReadyNAS RN314 storage device. I am trying to swap out the 4TB drives for 8TB. I have one problem though. The clips in the hard drive trays do not match the hole positioning on the new hard drives. The 4TB have a hole at the end on the socket side of the and a hole in the middle. However the new 8TB drives have the holes on either far end. So I can't get the clips to secure in since there is no middle hole on the drives. Is it possible to get trays/clips that match these drives? Or can someone recommend a work-around? Thanks!
That's them.
7 Replies
Replies have been turned off for this discussion
You need to remove the plastic mounting brackets from the disk tray and then screw the drive to the bottom. The needed screws should have been shipped with your NAS, so hopefully you have still them.
It is likely that only one pair of mount points on the bottom of the drives will align with the holes in the disk tray. But that is enough to secure the drive.
I am sure I don't have the screws anymore. I can surely buy extras though. Do you by chance know the screw size/type/spec?
The best source for screws is to use ones designed for Supermicro servers with 3.5" drives. You can buy a bag of 100 from Amazon, as well as others.
You will be unable to find appropriate screws in a hardware store. The pitch on the countersink is much more shallow than standard and using anything else will prevent the tray from being mounted.
NETGEAR Academy
Boost your skills with the Netgear Academy - Get trained, certified and stay ahead with the latest Netgear technology!
Join Us!
