Forum Discussion

Guide

Jan 09, 2017

Solved

Ultra6 LCD screen problem after 6.6.1 upgrade

Yesterday I upgraded OS from 4.2.30 to 6.6.1. More-less fine (usually fan problem and CPUtemp is constant), but one can't find: LCD screen error. It working 99%, but uncorrect at DISK3. It show only the top and bottom line from the little box (not the side lines), and no 3 in the box, just a small line in the right bottom corner, like an mirrored aphostrofe.

I have only 3 disk, no idea about DISC4-6.

All other working good, texts are perfect.

Any idea?

ReadyNAS OS 6 on Legacy models

adamwilt
Jan 13, 2017
I had the same problem on an Ultra 6 upgrading from 4.2.30 to 6.6.0 a couple of weeks ago. After I rebooted the disk array rendered properly and I haven't seen that visual problem since (lots of other things don't work reliably—I'm still not sure I shouldn't roll back to 4.2.28 or 4.2.30—but the front-panel display has been fine).

5 Replies

Replies have been turned off for this discussion

JennC
NETGEAR Employee Retired
Jan 09, 2017
Hello kekegsm,

Welcome to the community!

I am not sure if you should update tot he latest instead of going through 6.5.0 or 6.6.0 first since you are using a ReadyNAS OS4 unit. I suggest you back up the data first if you have already have them stored to the ReayNAS volume then factory reset or perhaps wait for other community members who have uploaded OS6 to their OS4 units too to respond.

Regards,
- mdgm-ntgr
  NETGEAR Employee Retired
  Jan 10, 2017
  Upgrading from RAIDiator-x86 to OS6 requires a factory reset so that will have already been done.
- kekegsm
  Guide
  Jan 14, 2017
  thx Jen, but I am sure, i can. Not the first NAS in my life, dont worry.
  
  adamwilt, after 4-5 reboot, it started to working. Weird.
  
  You wrote "(lots of other things don't work reliably". Please write them, maybe we can found something together.
  - adamwilt
    Aspirant
    Jan 16, 2017
    I've listed my various tales of woe at https://community.netgear.com/t5/Using-your-ReadyNAS/OS-6-6-on-Ultra-6-Not-ready-for-prime-time-Do-I-need-more-memory/m-p/1209505#M123199
adamwilt
Aspirant
Jan 13, 2017
I had the same problem on an Ultra 6 upgrading from 4.2.30 to 6.6.0 a couple of weeks ago. After I rebooted the disk array rendered properly and I haven't seen that visual problem since (lots of other things don't work reliably—I'm still not sure I shouldn't roll back to 4.2.28 or 4.2.30—but the front-panel display has been fine).