Why does the web interface show WNDAP360 for my WNAP320?

[goodbyeloou]

When connected to the web interface for my new WNAP320, the interface is for the WNDAP360.  The firmware version is for the 320.  Even after upgrading the firmware to a newer version for the 320, the interface still shows WNDAP360 in the top-right corner of the screen.  Firmware upgraded from v3.0.4 to v3.0.5.  Is this an issue with my new access point, or are they using the 360 interface on all of the 320 access points?

[goodbyeloou · Accepted solution]

Thanks, Raghu.  It was the browser cache.  Had not tried that, since everything else on the page was loading with the latest information.

Ben

[RaghuHR]

Hi Ben

Welcome to the Netgear Community.  Have you ever tried clearing browser cache and tried to access web UI? Please double check the IP address of your AP.

Please upgrade your WNAP320 to latest 3.7.4.0

You can download from the following link

https://kb.netgear.com/000046314/WNAP320-Firmware-Version-3-7-4-0

PS- Read the FIRMWARE UPGRADE SEQUENCE TABLE for the correct path.

Thanks

Raghu

[goodbyeloou · Accepted solution]

Thanks, Raghu.  It was the browser cache.  Had not tried that, since everything else on the page was loading with the latest information.

Ben