- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GSM7352S and GS748TS Unit Modes?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
GSM7352S and GS748TS Unit Modes?
We just installed a GSM7352S in our data room and replaced a unmanaged switch with a GS748TS on the 3rd floor of our office building. Is it the best to setup 2 connections with LAG and run the GSM7352S as master and the GS748TS in standalone?
Any other suggestions on how to get the best performance?
Thank you in advance,
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSM7352S and GS748TS Unit Modes?
Hi @prodigerati,
@prodigerati wrote:
We just installed a GSM7352S in our data room and replaced a unmanaged switch with a GS748TS on the 3rd floor of our office building. Is it the best to setup 2 connections with LAG and run the GSM7352S as master and the GS748TS in standalone?
You may setup LAG between the two switches.
I got confused with the term "master" that you have mentioned as this term is use in stacking switches. Stacking between the GSM7352S and GS748TS is not possible. Kindly check no. 5 on this link below as reference:
http://kb.netgear.com/app/answers/detail/a_id/20074/~/gs7xxts-tps-faqs
Welcome to the community!
Regards,
DaneA
NETGEAR Community Team