M4300 12x12 Problem speed with qnap 20Gb Lacp configured

[belhassench]

Hello 

I have problem with Netgear M4300 12x12 with Qnap TS-EC2480U R2 configured on each other 2 x 10Gb Lacp .

The link is up , but problem in speed.

when i copied from freenas (10gb + 10gb link aggregation configured) on qnap the speed is rate between 10mb/s to 100mb/s  , and from my computer to qnap or freenas , the speed rate between 10mb/s to 100mb/s.

FreeNas is LAGNASE1

QNAP is NASGLB

where is the problem

[DaneA]

@belhassench,

Welcome to the community! 🙂  

Kindly answer the questions below: 

a. What is the brand/model of the fiber modules you are using between the M4300-12X12F and the QNAP TS-EC2480U R2 as well as between the M4300-12X12F and FreeNAS? 

b. What is the bonding mode (or Hash mode) configured on the QNAP TS-EC2480U R2 and FreeNAS? 

c. Is LACP configured also between the M4300-12X12F and the PC?  

d. What is the behavior of the 10GBASE-X SFP+ port LEDs on the M4300-12X12F switches? 

e. What is the current firmware version of the M4300-12X12F?

Regards,

DaneA

NETGEAR Community Team

[belhassench]

@DaneA 

Thank you for the reply 

The firmware of the switch is 12.0.7.10.

The model of all fiber optic connected to M4300 :

• Lag1 between S3300 (First Floor) and M4300 : AXC761(Netgear) LACP.
• Lag2 between S3300 (Ground Floor) and M4300 : AXC7610(Netgear) LACP.
• Lag3 between S3300 (Second Floor) and M4300 : AXC7615(Netgear) LACP.
• Lag4 between M4300 ---> Qnap TS-EC2480U R2 : 02 cable : SFP-H10GB-ACU7M , CABLE-STRG Kawasaki 594060003.
• Lag5 between M4300 ---> Freenas server APY : 02 cable : PSF1PXA3MBLLN (Same Model).

The protocol used between Qnap and M4300 is lacp configured in Qnap 802.3ad dynamic.

And same in freenas. (STP off , Static off).

The led port in M4300 Swetch is green and 10G Full (The swetch is L3 switch).

LACP is not configured between the M4300-12X12F and the PC (L3 switch only).

[DaneA]

@belhassench,

I apologize for the late response. 😞 

The firmware of the switch is 12.0.7.10.

Let us update the firmware of the M4300-12X12F switch to the latest version which is v12.0.7.17 and you can download it here.  Then, check if the same problem will occur. 

LACP is not configured between the M4300-12X12F and the PC (L3 switch only).

Is your PC connected with 10G ethernet connection to the M4300-12X12F switch? 

Regards,

DaneA

NETGEAR Community Team