Reply

Re: S8000 Link Aggreation Grouping

Kris_Chen
Luminary

S8000 Link Aggreation Grouping

Hi, Guys:

Is there any way to setup more LAG Groups ? Not just only two - LAG1&2 in S8000 ?

I just want to utilize the LAG to speed up the data transfering from 3 sets of NAS. So I setup Port1&Port2 connected to NAS1 then Port3&Port4 connected to NAS2, finally Port5&Port6 connected to NAS3. As you know that NAS1&NAS2 are within the same LAG1 but NAS is  LAG2. After turning on LAG all port whatever LAG1 or LAG2. only NAS1&NAS2 cannot be logined but NAS3 can.

It seems to update the firmware to make more freedom in LAG grouping setting !

 

Model: S8000| GS808E Nighthawk Gaming & Streaming Switch
Message 1 of 2
schumaku
Guru

Re: S8000 Link Aggreation Grouping

As of writing, the S8000 (GS808E) on firmware v1.0.2.3 does only support the configuration of only two LAG. 

 

Each NAS must be configured to a mode supporting static trunking (Balance-RR, Balance-XOR), and only one NAS can be connected to one LAG. Note there are NAS trunking modes like Balance-TLB or Balance-ALB which can be used against switches without a static (or 803.2ad*) LAG config. Extending the product specs in accordance with Smart Managed switches (number of LAG = number of ports MOD 2) was discussed, however this never happened.

 

Regards,

-Kurt

PS. "Be aware 802.3ad LACP (802.1AX-2008) can't be configured on the S8000.

Message 2 of 2
Discussion stats
  • 1 reply
  • 1327 views
  • 1 kudo
  • 2 in conversation
Announcements

Orbi WiFi 6E