- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Nighthawk R7000P
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have two R7000P's and am trying to set 2nd as an AP. My 1st is 192.168.1.1 and I set the 2nd as 192.168.1.2. But when I make the change to AP mode for the 2nd.... I can no longer access the 192.168.1.2. Even if I reserve IP with MAC in 1st.... still can not access. It doesn't show in list of connected devices. Is there way to change channels in 2nd if unable to access through IP webpage?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry, nevermind. When I messed with this before, this was all that happened. When I tried starting over and doing again this time,,,, I can actually find 2nd in connected devices. It is different IP than what it was supposed to be but actually showed in list of connected devices whereas before it wouldnt be listed..
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sorry, nevermind. When I messed with this before, this was all that happened. When I tried starting over and doing again this time,,,, I can actually find 2nd in connected devices. It is different IP than what it was supposed to be but actually showed in list of connected devices whereas before it wouldnt be listed..
• Introducing NETGEAR WiFi 7 Orbi 770 Series and Nighthawk RS300
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more