I have 3 areas with soundproofing construction techniques implemented that cause enough interference that wireless does not penetrate well enough from one area to the next to be useful, but some weak signal does show in each area outside the main. I need wireless in each area, preference being all interconnected and broadcasting the same WIFI network SSID so that mobile devices (cells, laptops, etc) can traverse from one area to the next seamlessly to the end user. I have a RAX200 setup and working connected to a cable modem and two RAX80 currently unboxed and firmware updated but not configured. I have ethernet trunk lines in place that can connect the RAX80's to the 200 in the two "remote" areas. What configuration options do I have to deploy these in the manner described?
Sure you can hook them up and run them with the same ssid's. Make sure the 2 RAX80's are in ap mode.
It isn't going to be seamless like the orbi setup but it'll work. Devices might tend to be a bit sticky and not transition from one router to the next though. That's where the orbi system works well versus just using the same ssid for a router-ap setup.
