GS305E - VLAN Config

[C2L_Eu]

Hi All,

Hopefully this is an easy question to answer but have strggled for the last few days, trying every combination to get VLANs to work.

VLAN 10 - Management

VLAN 30 - Guest

VLAN 40 - Smarthome

Eth1-4 = These should be VLAN 40 tagged. They connect to devices like TV's or AMPS

Eth 5 = Truck to the rest of the network which has VLAN tagging working fine with WAC505's.

I've tried every combination of turning settings from T to U and also PVID to 40 for ports 1-4.

Attached is what my bad research says it should look like but doesnt work

Thanks for any help in advance.

[schumaku · Accepted solution]

---

@C2L_Eu wrote:

VLAN 10 - Management

Eth1-4 = These should be VLAN 40 tagged. They connect to devices like TV's or AMPS

Eth 5 = Truck to the rest of the network which has VLAN tagging working fine with WAC505's.

---

No, ports where you connect devices like TV, AMP, computers, IoT must be always untagged.

The screenshots provided look correct, #1-4 VLAN ID 40 Untagged, PVID 40. #5 VLAN ID 40 Tagged.  Double check the peer switch on the trunk is configued similar.

[C2L_Eu]

From the above, what I can see all traffic still goes to VLAN 1 as the IP range is that default not VLAN40 which from what i belive it should be.

Thanks

[schumaku · Accepted solution]

---

@C2L_Eu wrote:

VLAN 10 - Management

Eth1-4 = These should be VLAN 40 tagged. They connect to devices like TV's or AMPS

Eth 5 = Truck to the rest of the network which has VLAN tagging working fine with WAC505's.

---

No, ports where you connect devices like TV, AMP, computers, IoT must be always untagged.

The screenshots provided look correct, #1-4 VLAN ID 40 Untagged, PVID 40. #5 VLAN ID 40 Tagged.  Double check the peer switch on the trunk is configued similar.

[C2L_Eu]

It was the peer switch all along!

Thanks for you help