- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GSS108E does not restart after being off all night
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
GSS108E does not restart after being off all night
I have a Netgear GSS108E 8 port switch at my desk at home. Power to this area is turned off each night. In the morning it will not power on. If I unplug and leave a couple of days, it will start up again. I have updated to latest firmware V1.6.0.9 which has made no difference. Today I have turned off the power saving option to see if that makes a difference. Cannot see anywhere else to configure. Any suggestions?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSS108E does not restart after being off all night
Don't power it off? It uses 1.2watts in standby. Which isn't a whole lot
Does it do anything when its powered back on initially?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GSS108E does not restart after being off all night
The power led coming back on if power returning?
Ethernet link led becoming active with a wired network interface plugged?
Management IP becoming active?
Management IP remain reachable?
nothing a low power idle status IEEE 802.3az can cause 8-).