OS6.3.3 (Beta 9 10) for 2120 Network Bonding

[cpu8088]

with my 2120 the beta 9 cannot set up bonding with another eth

tried with different bonding methods but no luck. was using adaptive load balancing with 6.2.3.

[mikes512]

I confirm that I have the same issue

[cpu8088]

with my 312 also has 2 gigabit ethernet ports there is no such problem.

so the issue is in the arm version

[cpu8088]

tried with beta 10

2120 network teaming method still cannot be selected.

312 no prob.

[mdgm-ntgr]

Do you have a backup of your data on your 2120?

Can you try an OS Re-install (resets some network settings) then attempt to configure bonding again on the 2120?

[cpu8088]

yes i have backup

was upgrading from 6.2.3 beta 9

will do a fresh install 🙂

[cpu8088]

tried fresh install

no luck

now revert back to 6.2.3 beta 10

[Skywalker]

It is working here for me on RN2120, but only after I reboot the box. We'll look into that.

[cpu8088]

mine is the 2120 v2

it boot up with beta 10 but still cannot select the binding method and the lan lights not blinking with data flow.

[mikes512]

I have the following iSCSI configuration. I can now bind the NICs using Beta 10. I use round robin. However I only get traffic to/from one of the ESXi servers. It works fine with 6.2.3 T1751.

                    SW1
                    |---|      |-----|
    ----------------|   |      |N    |
ESXi1               |   |------|I   R|
    -----\    /-----|   |      |C   N|
          \  /      |---|      |1   2|
           \/                  |    1|
           /\                  |    2|
          /  \      |---|      |N   0|
    -----/    \-----|   |      |I   v|
ESXi2               |   |------|C   2|
    ----------------|   |      |2    |
                    |---|      |-----|
                     SW2

[cpu8088]

beta 11 solved this