- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WNDR4500v3 not running in 802.11n mode
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I have a Netgear WNDR4500v3 (N900) router and I've noticed that I'm actually running in my 2.4ghz band in 802.11g and my 5ghz band(which I use exclusively for gaming devices) is running in 802.11a. Shouldn't the router itself be running in n? I have a wireless card in my PC that supports wireless N and 5Ghz and when using WifiInfoViewer almost all the other networks around my area show up as N but my two SSID's do not. I've gone through the router control panel and I don't see anything to change it.... I'm no expert in networking, but I feel my router isn't reaching it's full potential and this could be why?
Anyways.... Thanks,
Keith
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WPA2 security is required for N check to be sure you're using it. Also WMM needs to be enabled too.
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
WPA2 security is required for N check to be sure you're using it. Also WMM needs to be enabled too.
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more