Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
RN 314 and NFS issue
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-12-27
02:29 AM
2014-12-27
02:29 AM
RN 314 and NFS issue
Hello.
I have a ReadyNas 314 (firmware 6.2.2) and 2x WD Red 4TB. I have setup and ESXi to use a new folder over NFS to make backups. I have used the same script over years on my old ReadyNas Duo but with this new one fail. Short time after start the backup my RN314 disconnect the esxi and I can´t access to the frontview. If I try to reboot the Nas via SSH (I started it after three hard reset) the system hung on rebooting...
I have lower NFS threads from 8 to 2 and my host has read/write and root permission
Is there anyone with the same problem? Any ideas?
Regards.
I have a ReadyNas 314 (firmware 6.2.2) and 2x WD Red 4TB. I have setup and ESXi to use a new folder over NFS to make backups. I have used the same script over years on my old ReadyNas Duo but with this new one fail. Short time after start the backup my RN314 disconnect the esxi and I can´t access to the frontview. If I try to reboot the Nas via SSH (I started it after three hard reset) the system hung on rebooting...
I have lower NFS threads from 8 to 2 and my host has read/write and root permission
Is there anyone with the same problem? Any ideas?
Regards.
Message 1 of 3
Labels:
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-12-27
03:00 AM
2014-12-27
03:00 AM
Re: RN 314 and NFS issue
Can you try to a new share with both Bit-rot protection and snapshots disabled.
Message 2 of 3
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2014-12-27
03:36 AM
2014-12-27
03:36 AM
Re: RN 314 and NFS issue
Hi mdgm, I have created a new share with the configuration that you said (That´s the same as I have before) and, at this moment, seems to work. I´m going to execute a full backup to test it.
(Although I have stopped some services to test it...)
Thank you.
(Although I have stopped some services to test it...)
Thank you.
Message 3 of 3