- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Ready Nas Adding a new disk
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ready Nas Adding a new disk
Hi Guys,
Following on from this thread...
...I have finally purchased a new drive.
Have put the new drive in and it has been tested ok.
Logs show..
Mon May 15 17:48:49 GMT 2017 | Data volume will be rebuilt with disk 2. |
In Volumes, the volume is greyed out.
In Status, the disk is still showing as Dead, with the old model number,
Disk 2 | Seagate ST32000542AS 1863 GB , 0 C / 32 F - Dead |
How do I tell it to do its thing??
Thanks
Terry
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
Hello h22solutions,
Before inserting this new disk, were you able to get to the files? I checked the previous topic and found that you have a ReadyNAS Ultra 4 which is a 4-bay NAS, do you only 2 disks with it? You may also need to include the firmware version on your response and if yoyu have full backup of the data.
Welcome to the community!
Regards,
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
Did the drive somehow get marked as a spare? It doesn't sound like it, but another user reported that as a problem.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
Yes, only 2 disks. Last time I swapped a drive, I think I just inserted it and it worked, but I could be wrong - it was a long time ago!! hehe
I dont have a backup of the single disk.
RAIDiator 4.2.30
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
Logs show "Data volume will be rebuilt with disk 2." (everytime it starts up.)
Health shows Disk 2 - yellow flashing indicator - Status = Dead
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
@h22solutions wrote:
I dont have a backup of the single disk.
I think you need one.
What model is the replacement drive, and how did you test it?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
Hi Stephen,
It's a brand new drive, I haven't tested it, other than place it in the machine.
I purchased 2 of thoses drives, so I'll test the other one in the nas drive and see how that goes.
Thanks for your help so far,
Terry.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Ready Nas Adding a new disk
@h22solutions wrote:
It's a brand new drive, I haven't tested it, other than place it in the machine.
Maybe check it with Seatools in a Windows PC (assuming you got the Ironwolf).