- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Unit stuck at calculating in the admin webpage #26274887
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Unit stuck at calculating in the admin webpage #26274887
Just upgraded to 6.4.1 yesterday morning- Unit seemed fine and responsive but all fields that should show available space show Calculating...
This morning the unit had a K error showing and was not responsive over the network. Had user power it off and back on. Which got file share and iSCSI working again. Any reason why it would show calculating for so long. Found that iSCSI became non responsive at 3:38am this morning. Otherwise it is running great but do need it to show the actual free space.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Unit stuck at calculating in the admin webpage
Sorry forgot to mention this is a ReadyNAS 314.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Unit stuck at calculating in the admin webpage
If you have antivirus enabled, try turning it off.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Unit stuck at calculating in the admin webpage
Yes I did. Same issue.
Thank you.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Unit stuck at calculating in the admin webpage
You might try support (if you purchased a new unit after ~June 2014 you have lifetime free chat/email support).
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Unit stuck at calculating in the admin webpage
Do you recall which firmware you updated from?
Unfortunately I can't view the logs attached to the case.