- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Re: Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory rese
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory reset
I have a Pioneer pro 6 with 2 Logictech transporters. Everything was working fine until a recent move. I had 2 hds damaged during the move. I had to replace the hds, and do a factory reset. I reinstalled the data, and now I can listen to radio over the Transporters, but when I try to access the server, the Transporter identifies that it is there, but when I try to access it, the transporter shows an "x" beside the server name. Support at Logictech is less than useless. Any ideas?
Greg
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory rese
Perhaps you need to install/update an add-on that you were using before the factory reset?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory rese
Thanks for the reply. Already did that...
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory rese
Which firmware are you running?
Which add-on and version?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Please help! Problems with a Netgear Pioneer Pro 6 and a Logitech Transporter after factory rese
Finally, after hours of screwing around, I deleted the current version of the Logitech Media Server (7,75) and tried 7.8. That didn't work so I deleted it and went back to 7.1. That worked! Does anyone know in which version Netgear took the LMS out of the streaming services tab in frontview, and added it to the add-in page?