- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
Upgraded to 6.6.0 and am now having performance issues
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
After upgradiing my firmware to 6.6.0 access to my netword raid is almost unusable. We have a pretty stable network with a small user base and have tried different forms of access to the raid via network in order to scratch off issues related to any of the work stations.
I read that there was a similiar issue when version 6.4.1 was released, but that seems to have been taken care of on version 6.5.0.
Any thoughts?
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
Do you have ipv6 disabled on the NAS?
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
That seems to be it! Thanks
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
oh man, now I did it.
It went back to slow performance, and I thought it might be a good idea to switch from ipV4 to ipV6.... and now I can't access the admin.
I've restarted the NAS and no dice.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
Boot mode -> OS Reinstal {sigh}
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
Just to wrap this up....
I continued having poor performance even after disabling ipv6.
All of the computers on our network are running MacOS, so I had set the acess to all my shares as AFP, however, I tried adding SMB access to all the shares and voilà... problem fixed.
I even enabled ipv6 again, and things continue to run smoothly.
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: Upgraded to 6.6.0 and am now having performance issues
Hi jonalexfilms,
Thank you very much for the feedback. If your issue is now resolved, we encourage you to mark the appropriate reply as the “Accept as Solution” or post what resolved it and mark it as solution so others can be confident in benefiting from the solution.
The Netgear community looks forward to hearing from you and being a helpful resource in the future!
Regards,