Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
WPN802 - AP Configuration and deploy
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2012-12-13
12:58 PM
2012-12-13
12:58 PM
WPN802 - AP Configuration and deploy
I set up a WPN802 to be connected into a WINDR4000 wifi router. I used DHCP for the address and SSID the same as the wifi router. I plugged it into an open port on the router and now there is a device on the main router's attached devices list with the SSID name, but I can't connect to it. I was hoping I could get to the admin panel in case I needed to make additional configurations, else I will have to reset factory defaults and start over.
Also, how do I know if it is getting used by wifi clients? It is within the network so how do we know if we are on it or the original router?
Thanks, I have other questions but hope this can be resolved first. :rolleyes:
Also, how do I know if it is getting used by wifi clients? It is within the network so how do we know if we are on it or the original router?
Thanks, I have other questions but hope this can be resolved first. :rolleyes:
Message 1 of 2
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
2012-12-13
05:37 PM
2012-12-13
05:37 PM
Re: WPN802 - AP Configuration and deploy
been totally different hardware , used different SSID names
Message 2 of 2
Announcements
• What is the difference between WiFi 6 and WiFi 7?
• Yes! WiFi 7 is backwards compatible with other Wifi devices? Learn more