Forum Discussion

Aspirant

Jul 30, 2015

LLDP on ProSafe GSM7248

Has anyone have much luck enabling LLDP on ProSafe GSM 7248 class managed switches? Below are my attempts (GSM7248) (Config)#ll? (GSM7248) (Config)# (GSM7248) >ena Password: (GSM7248) #...

Installation

Troubleshooting

sndlt

Aspirant

Jul 31, 2015

Thank you. I'll try that tomorrow when I get to office.

So this means I have to give interface(mgmt) an ip to access?

JohnRo

NETGEAR Employee Retired

Jul 31, 2015

Hello sndlt,

Yes, you'll have to give it an IP address for web access. You can follow this old version of the install guide found on our product support page, the document is a bit old but still applies.

I'll look forward to your response.

Thanks,

sndlt
Aspirant
Aug 03, 2015
Having trouble getting a private IP from the department that manages IP addresses.

Is it possible to set a point-to-point straight layer 3 interface between a netgear port and my PC?

After that, I would get rid of the lay 3 interface in switch.

Would that disable LLDP once it's been activated?

Thanks!
- JohnRo
  NETGEAR Employee Retired
  Aug 04, 2015
  Hello sndlt,
  
  You can use a computer with a static IP when there is no DHCP present. The switch has a default IP of 169.254.100.100, subnet 255.255.255.0. Just set the PC's IP to the same range and you should be able to access it. Once you have done this, Web Loging should be available. I don't believe the layer 3 interface is needed at this point.
  
  Hope that helps! Feel free to ask if you have any more questions.
  
  Thanks,
  - sndlt
    Aspirant
    Aug 13, 2015
    Just gave it management IP and http into it.
    
    However, I don't see a LLDP per screenshot below.
    
    Do I need to update firmware or is it just not available in this model?
    
    Thanks.