Forum Discussion

Aspirant

Oct 03, 2015

Solved

Can't get GS110TP to work as simple as GS105E

For my work I have to check services going over utp links in different vlans. I used a GS105E with its mirror function. I can connect the GS105E without any vlan configuration and all traffic of dozens of vlans passes transparent over the switch.

Now I have to do the same over fiber optics and got a GS110TP for that but can't get it to work as simple as before with the GS105E.

Now it looks like that I have to configure a lot of vlans and that the GS110TP is restricted to 64 vlans.

Does someone know how to do it similar on the GS110TP as on the GS105E?

gs105e

GS110TP

Installation

APDK66
Oct 11, 2015
So I understand I can't use this switch for what I want. I need to check uplinks containing 250+ vlans.
Besides the different configuration effort each time it has a limit of 64 vlans.
I have to look for another solution.

10 Replies

DaneA
NETGEAR Employee Retired
Oct 04, 2015
Hi APDK66,

Kindly answer the questions below:

a. What is the current firmware version of the GS110TP?

b. Have tried to reboot the GS110TP?

c. Have you tried to perform a factory reset on the GS110TP?

I look forward to your response. Welcome to the community! :smileyhappy:

Regards,

DaneA

NETGEAR Community Team
- APDK66
  Aspirant
  Oct 05, 2015
  Hi DaneA,
  
  thanks for your answer,
  
  The switch has firmware version 5.4.2.19. I did reset and do a factory reset.
  The current situation under test:
  - factory default setting
  - link with vlan 4, 6 and 7 connected to port 1 & 2 of the switch.
  
  no traffic passes the switch.
  
  Arjan
  - DaneA
    NETGEAR Employee Retired
    Oct 05, 2015
    Hi APDK66,
    
    Here are my follow-up questions below:
    
    a. Are ports 1 and 2 of the GS110TP connected to another switch?
    
    b. What are the port members of VLANs 4, 6 and 7?
    
    Kindly post a screenshot of your detailed network setup.
    
    Regards,
    
    DaneA
    
    NETGEAR Community Team