Forum Discussion

Apprentice

Sep 06, 2016

Solved

WNDAP350 CLI Factory Default syntax

Hi, Firmware has left me with a cut down 'cloud connect' type GUI. I need to reset via CLI as suggested by the firmware upgrade notes as the button reset did not restablish the full GUI. I have...

DaneA
Sep 07, 2016
Hi flattened,

Kindly answer the questions below:

a. What is the current firmware version of the WNDAP350?

b. Do you want to use the WNDAP350 as a standalone access point? If yes, kindly access the web-GUI of the WNDAP350. Then go to Configuration > Sysytem > Basic > General > Cloud Setting. Then, disable the cloud option and apply the setting.

I look forward to your response.

Regards,

DaneA

NETGEAR Community Team

DaneA

NETGEAR Employee Retired

Sep 07, 2016

Hi flattened,

Kindly answer the questions below:

a. What is the current firmware version of the WNDAP350?

b. Do you want to use the WNDAP350 as a standalone access point? If yes, kindly access the web-GUI of the WNDAP350. Then go to Configuration > Sysytem > Basic > General > Cloud Setting. Then, disable the cloud option and apply the setting.

I look forward to your response.

Regards,

DaneA

NETGEAR Community Team

flattened
Apprentice
Sep 07, 2016
Thankyou - I was so surprised by the loss of functionality I did not even SEE that option until you pointed it out.
All fixed.
Andy
- DaneA
  NETGEAR Employee Retired
  Sep 07, 2016
  Hi flattened,
  
  I'm glad that its all fixed now. :)
  
  Feel free to post your future concerns here in the community.
  
  Cheers,
  
  DaneA
  
  NETGEAR Community Team