After upgrading my ReadyNAS Pro to RAIDiator 4.2.12, I now experience uncontrolled system starts.System now boots up uncontrolled at least three times a day when turned off.Of course, scheduler an WoL are disabled.Any ideas what that might be caused from?Thanx & Best Regards

i had the very same issue with 4.2.12. the nas booted up totally out of the blue whenever it felt leike it.downgrading to 4.2.11 solved that issue and it fixed another problem for me as well. 4.2.12 reports cpu temps 5°C higher than 4.2.11, which can cause the nas to generate warings about cpu-temp.

I also have the same problem with the PRO turning on a few minutes after it turns off from a scheduled shutdown. I ended up turning off the auto power feature until they come up with a fix. I also noticed that the PRO was giving me the temperature warnings with new 4.2.12 firmware. I hope they come out with the fix soon.

I also just realized that the RNP from time to time refuses to boot up properly and simply hangs.Pulling the plug for 30Sec helped, but this workaround is nothing to live with.I´ll asap downgrade to 4.2.11 and wait for a fix.Thanx!

Do you have any power schedule set up? If so, how is it configured, and if not, have you had it configured previously? Do you see anything in your logs (from the logs page in Frontview) indicating a scheduled power up?

As I said: there was NO schedule activated, Wake on LAN was disabled.I also encountered the temperature warning mentioned earlier in this thread.Booting successfully was a gamble, each time - half of my attemps failed.I just downgraded to .11 and realized that my AFP access rights were all lost.I am currently re-assigning access-rights and hope that .11 will run as stable as prior to the upgrade.Any suggestions?Thanx & Greets,Lars

Uncontrolled power-ups with RN Pro after Raidar Upg.

56 Replies

Replies have been turned off for this discussion

tark
Tutor
Jun 16, 2011
support is their any update on this issue ?
tark
Tutor
Jun 17, 2011
bump
Jedi_Knight
Tutor
Jun 18, 2011
Please contact support and open the case if you are having issue with current 4.2.17 release.
Jedi_Knight
Tutor
Jun 30, 2011
Tark,

We will get this fix in next release. Thanks.
BotanyBay
Tutor
Sep 27, 2011
I just received an RMA unit for a different problem and the new unit has this issue. it always boots when power is first applied and if i turn it off with two presses of the blue button it comes back up in about 4 minutes.

I put in a single spare disk - updated the firmware to 4.2.17 which is what i was using before - powered down - installed 6 disks and it came right up. however unit will not stay powered off more than 5 min before reboot.

this is second rma
- original unit stuck not finding disks and saying readynas
- first rma temp 2 sensor went to 190F during weekly parity scrub of raid but normal otherwise probable thermal grease issue
- second rma arrived with 4.2.12 firmware (if memory serves) so flashed to 4.2.17 with spare disk but will not stay powered off

any suggestions? this is a pro business edition.
BotanyBay
Tutor
Nov 04, 2011
Ended up with a new unit, everything is working well at this point! Thanks for the support!!!

Forum Discussion

Uncontrolled power-ups with RN Pro after Raidar Upg.

56 Replies

Related Content

Netgear ReadyNAS 104 won't power up.

ReadyNAS NV+ won't power up

Raidar

RN314 won't power up

Power supplies mized up

NETGEAR Academy

ProSupport for Business