- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
GS752TP firmware upgrade path
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All,
Is that any firmware upgrade path for upgrading on NETGEAR GS752TP from 6.0.1.18 > 6.0.1.30 ?
Can I upgrade directly from 6.0.1.18 to 6.0.1.30 ? or I have to upgrade step by step e.g. 6.0.1.18 > 6.0.1.24 >6.0.1.29....
Thanks for your advice.
##GS752T
#Firmware
#Upgrade
Solved! Go to Solution.
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Debtless4941,
it's always a good thing, before upgrading, to read the release notes for each FW, which you can find as followed:
Then, the release notes, should advise, on any upgrade path, if there is one to take.
But, as we can see, there is no mention of following a specific path, therefore it should be safe to go from 6.0.1.18 directly to 6.0.1.30.
Mike
All Replies
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Debtless4941,
it's always a good thing, before upgrading, to read the release notes for each FW, which you can find as followed:
Then, the release notes, should advise, on any upgrade path, if there is one to take.
But, as we can see, there is no mention of following a specific path, therefore it should be safe to go from 6.0.1.18 directly to 6.0.1.30.
Mike
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Re: GS752TP firmware upgrade path
Thanks @MikeD1234, it was very helpful.